Zenith 36VEI-9 carburettor?

This forum is for non members to ask questions to the ATDC Members. Members should use the private forums for any and all Member to Member conversations.
Post Reply
Rod
Posts: 77
Joined: Sun Nov 24, 2019 9:44 am
Location: New Zealand

Zenith 36VEI-9 carburettor?

Post by Rod » Sun Aug 28, 2022 11:12 pm

For a Sept 1938 build Goodwood, I'm hoping someone can put me on to a useable 36VEI-9 either CS 762 or CS 883 (the CS number should be stamped on the side of the base flange). The CS 762 one should also have F1365 stamped in the 'number' field on the float bowl cover part of the body ( I don't have a number for the CS 883). These CS numbers are for 23mm and 25mm choke respectively
I've contacted both Burlen/Zenith and Eric at the Carburettor Hospital (both unable to assist with replacement) and have an enquiry out with Alderton Austin. As I'm on the opposite side of the world its a bit hard to find likely sources in the UK without some inside knowledge from UK residents.
Thanks in Advance
Rod

richard_mallet
Posts: 139
Joined: Mon Nov 25, 2019 10:22 am
Location: Marlow, Buckinghamshire

Re: Zenith 36VEI-9 carburettor?

Post by richard_mallet » Tue Aug 30, 2022 10:36 am

Hello Rod,

Try this company.

www.gowerandlee.co.uk

Good luck.

Richard

Rod
Posts: 77
Joined: Sun Nov 24, 2019 9:44 am
Location: New Zealand

Re: Zenith 36VEI-9 carburettor?

Post by Rod » Wed Aug 31, 2022 10:06 am

Thanks! I've emailed them
E: They can't help but have referred me to another firm...

Post Reply