Petrol pump 10/4 1933

This forum is for non members to ask questions to the ATDC Members. Members should use the private forums for any and all Member to Member conversations.
Post Reply
Jasper
Posts: 65
Joined: Wed Jul 21, 2021 9:30 am
Location: Hailsham East Sussex

Petrol pump 10/4 1933

Post by Jasper » Sun Apr 10, 2022 8:09 am

Morning
May be a silly question, but i have fitted an electric fuel pump to Elsie and want to refurbish the mechanical glass bowl one. Can i just fit a blanking plate temporarily ???
Thank you in advance

GaryCullen
Posts: 58
Joined: Wed Nov 20, 2019 1:34 am
Location: New Zealand

Re: Petrol pump 10/4 1933

Post by GaryCullen » Mon Apr 11, 2022 4:44 am

Can’t think of any reason why not Jasper.
You will want to use a gasket behind the plate to “limit” oil weeping down the outside of block.
These engines seem to generate a lot of oil splash and mist. This side of the engine relies on mist being forced up into the valve chest via 3 ( or 4 ) quite small holes to lubricate the followers and tappers. The opening for the mechanical fuel pump is just below the valve chest.
Cheers
Gary
Auckland
NZ

Rod
Posts: 107
Joined: Sun Nov 24, 2019 9:44 am
Location: New Zealand

Re: Petrol pump 10/4 1933

Post by Rod » Mon Apr 11, 2022 7:49 am

Agree, no reason why not. I have done it to several other makes for similar reasons (once or twice it ended up a permanent fixture).
Just use a pump mounting flange gasket as a template to cut from, I usually cut them out of a piece of scrap 1/4" aluminium plate with a jig saw, but even wood or plastic would do, there is no significant pressure behind it, just lots of oil splash.

Jasper
Posts: 65
Joined: Wed Jul 21, 2021 9:30 am
Location: Hailsham East Sussex

Re: Petrol pump 10/4 1933

Post by Jasper » Tue Apr 12, 2022 9:11 am

Hi
Many thanks for your help... will commence today!!!
Regards

Post Reply