Hi Allan
You wont remove valve guides with a punch you need a better tool than a simple punch, where abouts in the country are you based I am based in Sheffield and could help you out if you were close on
Regards Ollis
Search found 8 matches
- Sun Mar 23, 2025 3:52 pm
- Forum: Public Requests For Club Assistance
- Topic: Valve guide punch
- Replies: 8
- Views: 46613
- Fri Mar 07, 2025 4:53 pm
- Forum: Public Requests For Club Assistance
- Topic: 1932 Austin 10 Dynamo Noise
- Replies: 8
- Views: 35480
Re: 1932 Austin 10 Dynamo Noise
Hi Dave
If its a 1932 dynamo I guess its a three brush and not a two brush dynamo I have some spares off an old three brush dynamo but I cannot picture the part you need if you could send a photo of part I will see if I can Help
Regards Ollis
If its a 1932 dynamo I guess its a three brush and not a two brush dynamo I have some spares off an old three brush dynamo but I cannot picture the part you need if you could send a photo of part I will see if I can Help
Regards Ollis
- Fri Feb 10, 2023 2:18 pm
- Forum: Public Requests For Club Assistance
- Topic: Andre Hertford Shocker absorbers measurements
- Replies: 1
- Views: 10678
Re: Andre Hertford Shocker absorbers measurements
Hi Jack Andre Hertford front shocker both arms are the same length 4 inch from centre to centre of bush Andre Hertford rear shocker different length arms the upper arm is 7 inch from centre to centre of bush and the lower arm is 5 1/2 inch from centre to centre of bush Hope this helps Regards Austin...
- Tue Feb 07, 2023 4:59 pm
- Forum: Public Requests For Club Assistance
- Topic: Mid 1933 10/4 steering box removal
- Replies: 4
- Views: 18865
Re: Mid 1933 10/4 steering box removal
hi Gary
Yes steering wheel off, trafficator switch off, draw the cables out from the bottom, disconnect from steering rack, undo the two bolts holding it to the chassis and the coulomb will draw out trough the engine bay
Regards Austin Ollis
Yes steering wheel off, trafficator switch off, draw the cables out from the bottom, disconnect from steering rack, undo the two bolts holding it to the chassis and the coulomb will draw out trough the engine bay
Regards Austin Ollis
- Fri Sep 09, 2022 8:56 am
- Forum: Public Requests For Club Assistance
- Topic: 1932 Austin Ten Sedan
- Replies: 1
- Views: 11479
Re: 1932 Austin Ten Sedan
Hi If I am thinking of the right rubbers these are the ones that go over the two metal tab the stick up to stop your luggage moving about You will not purchase these any where, I dont know if you are a practical type of person or not but I made mine out of a product called liquid rubber I made them ...
- Sun Jul 03, 2022 2:24 pm
- Forum: Public Requests For Club Assistance
- Topic: Zenith carb adjustment on 1933 10/4
- Replies: 3
- Views: 17486
Re: Zenith carb adjustment on 1933 10/4
Hi The carburettor is getting its air from another source, even though you have fitted a re build kit I suspect air is still passing the spindle because of wear in the body of the carburettor a simple test would be to start the engine and spray WD 40 around either end of the spindle if air is still ...
- Tue Feb 01, 2022 6:25 pm
- Forum: Public Requests For Club Assistance
- Topic: Elsie's owner is an idiot!
- Replies: 8
- Views: 32348
Re: Elsie's owner is an idiot!
Hi Jasper You need to take all the plugs out and using the stating handle bring No2 piston really slowly up to the top get someone else to help you one watching the piston and the other carefully tuning the handle then with a piece of soft copper wire you should locate it with plenty of patience Reg...
- Wed Oct 06, 2021 4:13 pm
- Forum: Public Requests For Club Assistance
- Topic: Indicators
- Replies: 7
- Views: 33659
Re: Indicators
Hi Daren Between 33 /34 our car didn't have indicators between 32 / 33 they introduced officiators so for me if you want indicator on your car to make you more noticeable to other drivers and safer I would go down the discrete route and put them in the side light and tail light and keep the car look...
